EN: the fan is directly powered from 5V power supply.P34: the fan is program-controlled via P34 pin.
Right: disconnect the CP2102 serial port and Raspberry Pi serial port.Left: connect the CP2102 serial port and Raspberry Pi serial port.VGx power config jumper: config the I/O level.Green: Raspberry Pi operating status indicator.Si3404 PoE power management chip (bottom side).LAN9514 (bottom side): fully-integrated USB hub and 10/100M Ethernet controller.TF card slot (bottom side): insert a Micro SD card with pre-burnt system, to start up Compute Module 3/3+ Lite variant.
1N4148 inverse across the series opto+LED combination to prevent possible reverse breakdown from transients. Also, it would be best to add a diode eg. USB SLAVE interface: allows you to burn system image into Compute Module 3/3+ To get the most benefit from this, the +5V supply should be completely isolated from the 3.3v.USB TO UART interface: for serial debugging.CSI interface: 2x CSI camera ports, for connecting Raspberry Pi Camera.USB ports: 4x USB ports, for connecting USB devices Raspberry Pi GPIO header, for connecting sorts of Raspberry Pi HATs 10/100M auto-negotiation Ethernet port, with PoE enabled 4x USB ports, allows connecting more USB devices.DSI interface: display ports, for connecting Raspberry Pi LCD.PoE enabled Ethernet port: 10/100M auto-negotiation, for connecting router or switch with PoE function.Raspberry Pi GPIO header: for connecting Raspberry Pi HATs.(This part is often used with optos, but works just fine as a buffer by itself. Share answered at 14:42 Jim Paris 2,655 1 10 11 Add a comment 0 If you dont need galvanic isolation, a bidirectional buffer like the NXP P82B96 may be all that you need. Compute Module interface: for connecting Compute Module (CM3 / CM3L / CM3+ 8G / CM3+L) 3 You want the ADUM1250, which is not optical but is an isolator.Power supply: micro USB port / PoE Ethernet port.Adopts isolated SMPS (Switching Mode Power Supply).
Onboard HDMI / DSI interfaces for connecting displays.4 x USB ports, allows connecting more USB devices.10/100M auto-negotiation Ethernet port, with PoE enabled.Raspberry Pi GPIO header, for connecting sorts of Raspberry Pi HATs The optical interface adopts imported HIFI-grade high-quality optical fiber socket and the coaxial interface adopts Pluse audio input isolation transformer.It already comes with optical and electrical SPDIF outputs. With the PoE (Power over Ethernet) feature, and versatile onboard peripheral interfaces, it is suitable for evaluating the Raspberry Pi compute module, also is an ideal choice for end products. The boards shown here work with all Raspberry Pis that are equipped with the 40-pin GPIO. The Compute Module PoE Board is a development board that you can plug a Raspberry Pi Compute Module into, and make use of the resources of Pi more flexibly. Note: The Compute Module is not included, please get it separately. The perfect composite breakout board for developing with Raspberry Pi computer module: This is the IO Board with PoE (Power Over Ethernet) for compact Raspberry Pi board - Compute Module. Lithium Ion Rechargeable Battery and Charger.Lead Acid Rechargeable Battery and Charger.All Rover 200 series products can be used in conjunction with a USB hub to provide connections to multiple devices.įull speed (12Mbps) & low speed (1. Given the low price of these units, many customers opt for the 200 series to save time on sourcing and fitting cables. Rover 200-1 has 3 ft of fiber optic cable fitted and fulfills the role of a USB isolation device perfectly. The Rover 200 series comprises a pair of USB extenders with fiber optic cable factory fitted between them. Ideal for extending USB in noisy environments.High reliability & high compatibility plug 'n' play devices.